Magic Circle Trampolines

Magic Cage Installation Instructions

16' Octagon

with 8 - 1 piece foam and steel poles

READ THROUGH INSTRUCTION BEFORE ASSEMBLING YOUR MAGIC CAGE

 

Assemble the frame in accordance with step 1 of the “Trampoline Assemble Instructions”, with the sockets on the legs to the outside, ignore step 2 and continue with these instructions.

 

 

New Step 2 There are 8 cage uprights (which are packaged with the foam), with a notch at the top to attach a spring.  Hook a spring into the pipe notch, turn to lock with the hook pointing up and set the upright in the socket on the leg with the spring pointing towards the center.

 

Step 3 Unfold the trampoline mat/cage unit.  At the top are 8 v-ring attachments, which the cage unit will hang from. Make sure that the bottom of the cage (112 v-rings) has the v-rings to the outside.

 

Step 4 Hang the cage from the 8 uprights one at a time (either remove upright from socket to reach springs or stand on ladder to reach.) Note the spacing between the v-rings at the top of the cage is not the same.  There are 4 short sides and 4 long sides.  The short sides need to go between the legs of the trampoline; this puts the door on the length of top rail (frame) with no joint.

 

Step 5 The first springs that should be attached to the cage and the mat, are the springs second from the corners of the mat.  Hook a spring into the v-ring on the mat and then to the frame. It is best to do 2 springs on one side then 2 springs on the opposite side.  Repeat until the 2nd spring from each corner is attached. ( #2 and #13 in each section)

Step 6 Now attach every third spring, in the same manners as in step 5, and continue hooking every third spring to the v-rings until all springs are attached.  (except for the v-rings closet to the corner, as this is where the safety pads are attached.)

 

Step 7 Install the safety pads as per the installation instructions.  Your assembly is now complete. 

 

 

Enjoy your “MAGIC CAGE” trampoline.